Recently completed a "near" total
retro-fit of 2001 - 41' Beneteau
411. More photos coming soon...
Old sheave VS new with ball
bearings...
New stereo head and DVD player
custom install
Total replacement of Nav station
equipment with
Rear view of the photo on the left
new wood panel, new 12 breaker
BlueSea 12v aux.
showing that not only is the layout
panel with the new Vessel Systems
Monitor VSM
and fit & finish "perfect" but the
422, Icom 504 VHF radio & Icom
single sideband wiring and cable bundles are neatly
radio, Garmin GMI-10
color display for all NMEA
laid out and safely tied.
2000 data, and the Xantrex remote
panel top ctr. Note two Cantalupi dimmer
packs in the
upper left corner, each has 3
channels.
Cantalupi "Falcon" 6 button Cantalupi LED Dimmer switches
with LED
Light switch that controls the two back lighting
for forward cabin with 3 light
banks.
dimmers for all main salon lighting.
This has LED rings surrounding each
momentary button.
New Xantrex MS 3000
Inverter/Charger
Cantalupi LED Reading light - Touch
on -Touch off
with Garmin XM,
Depth, Network expander
and Navico AIS 300 "off" camera all
neatly
installed and wired in.
New custom cushions port side
settee
in Brisa Ultraleather... New
custom cushions starboard side main
salon area
Notice LED accent lighting over
side windows...
New replacement single handle
faucets in galley and in aft &
forward heads, all with pull out
sprayers
Galley has side faucet from
Seagull IV water purifier / filter
housed under the sink.
Looking down into compartment
with new fresh Top
of mast with Maratron Ultrasonic
wind instrument,
water pump and whole boat fresh
water Lopo LED mast top tri-light with
anchor light with Windex
filter
system
attachment on top, Digital VHF
antenna and static dissipater
BEFORE: Old style helm with Yanmar
control panel New Helm station with NMEA 2000
engine data NOTE: folding wheel folded out of
the way for photo Garmin 5212, along side Garmin GMI
10 NMEA
2000 display, Ray Marine Autopilot,
start/stop rocker
switch and boat shaped bow thruster
control
Bow thruster install... old
bottom paint Bow thruster after install and new
bottom paint job with
three coats of Micron 66 first one blue
as flake coat with
two black top coats
This is what the
professional surveyer says about our
work below...